Quantum Q4 - Comfort Adjustments - Controls; Controller Position Adjustment

16
COMFORT ADJUSTMENTS
NOTE: If your power chair is equipped with a TB-Flex Seat,
a Synergy Seat, or TRU-Balance® 3 Power Positioning
System, refer to the seat adjustment information
contained in separate manuals.
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either
left-hand or right-hand use.
Prevent controller harness damage! Avoid routing the
controller harness on the outside of the armrest pad.
Route the harness under the armrest or toward the
inside of the armrest pad. Use correct tie-down points
for the controller harness to prevent the harness from
getting caught in the wheels, pinched in the seat frame,
or damaged when passing through doorways.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector from the rear of the
power base. See figure 3.
3. Remove any wire ties securing the controller harness to
the armrest.
4. Loosen the adjustment knob on the armrest where the
controller is currently located. See figure 14.
5. Relocate the controller to the desired armrest and tighten
the adjustment knob to secure the controller.
6. Use wire ties to secure the controller harness to the
armrest.
7. Route the controller harness to the front of the power
base and reconnect the controller. See figure 15.
MANDATORY!
Figure 14. Controller Position
Figure 15. Cable Routing