while the current consumption of the TX output stage (in mA)
is also displayed on the screen. When you press any of the Up
or Down buttons, the device switches to the mode of
automatic selection of the resonant frequency according to
the maximum current of the output stage. To save this setting,
click the “OK” button. When exiting “Esc”, the setting is not
remembered.
Voltmeter - correction of the battery level indication. The
voltmeter value is changed using the "Right" and "Left"
buttons. “OK” - exit with saving the result, “Esc” - exit without
saving.
U min — Sets the threshold for the low battery warning. The
value is changed using the "Right" and "Left" buttons. “OK” -
exit with saving the result, “Esc” - exit without saving. When
powered by two Li-ION batteries connected in series, set the
value to 6.0V
Ferrite calibr ferrite calibration. Allows you to set the initial
value (ZERO) of the VDI scale. Take the angle of response from
ferrite as 0 degrees (if in very simple words, it allows the
device to understand where copper is, where ferrous metal,
etc.). Manual mode is possible, in which the “Left” and “Right”
buttons set the angle of rotation (delay) in degrees. In this
case, the response level is displayed in the upper line, moving
a piece of ferrite over the coil, and changing the angle of
rotation, it is necessary to achieve a minimum deviations of
the level indicator from 0. By pressing any of the Up or Down
buttons, the device switches to the automatic ferrite
To Next Page
Loading...