● High-quality and high-definition image FULL HD 1080P DV DC
● 155-degrees wide-angle lens
● Compact design, portable handheld DV DC
● Can record high-definition video in low light
● Video format
：
1920×1080P
● Camera mode：12M（4032×3024）
● Motion detection recording
：
720P and 1080P
● High-speed transmission USB 2.0 interface
● Maximum compatible with 32G T-flash card
● TV-OUT can Connect to the TV display
● Built-in lithium battery for up to 60 minutes recording continuous
Built-in chargeable lithium battery
，
should charge the battery at the first use, and can
be charged in those ways:
1 Connect to the computer for charging, use USB to connect to the computer
；
2 Charging and recording at the same time, you can film video and also charge
（
connect USB 5V charger or mobile charger）
3 The red light flash during charging while the blue light is off, when the charging is
finished, the red light is on continuously and the blue light is off.
（
The red light is on
continuously, please keep charging for more 30 mins to make sure that the battery is
Note
：
1 When the battery is low and the TF card is full, the DV red and blue lights
flash for 5s then directly power off into the protected status.
（
Save record files and power off automatically), at this time, please charge the
2 When it is powered on without card ， the red and blue lights flash for 5s then
3 If there is no working mode after power on, will be powered off automatically in 1
USB cable and TV cable are combined into one cable with following three functions:
1 Can connect to the computer for charging and the data transmission.
2 Can insert the TV OUT screen display.
3 Can be inserted from outside the DV-5V for recording and charging at one time.
No flashing during recording 720P：
Press the ON OFF button to turn on the power, after power on, the blue light is long on
in the standby mode, press the power button for 1 time and the blue light is off after
flashing for 3 times then get into the 720P recording mode ， during the process of
recording the light will not prompt and the recording files will be saved every 5 mins,
press the power button again when you want to stop recording, and the camera will be
back to the standby mode mean while the blue light will be on.
No flashing during recording 1080P
：
Press the ON OFF button to turn on the power, after power on, the blue light is long on
during the standby mode, press for 1 time the mode button，the camera turns into 1080P
mode and the blue light and red light are long on
，
after that, press the power button
again, the blue light and red light flash for 3 times then are turning into the 1080P
recording mode, during the process of recording light will not prompt, the recording files
will be saved every 5 mins, press the power button again when you want to stop
recording and the camera will be back to the standby mode and the blue light will be on.
Photo shooting 12 million pixels：
Press twice the mode button in the standby mode, the red light is on and the blue light is
off, then press the power button again, the red light flash for 1 time, the camera will take
one picture and the pictures of 12 million pixels will be saved automatically.
The infrared light turns on and off
：
Turn on
：
during every mode of standby, press the ON/OFF power button for 2 seconds
，
the red light flashes , IR light is on and you can start the night recording.
Turn off
：
turn off the IR light, in every mode of standby, press the ON/OFF for 2
seconds, and the left and right light flash for 3 times, then the IR light mode will be turn
Motion detection recording mode
（
720P -1080P
）：
Motion detection recording mode 720P
：
in the standby mode of blue light, press the
mode button for 3 seconds, the blue light is long on and the red light is off when the
motion detection recording mode turns on, after detecting the movement of the object, the
red light and the blue light are flashing at the same time for the motion detection
recording 720P, the recording files will be saved every 5 mins until there is no motion or
no battery or the card is full.
（
press any button can exit the motion detection recording
Motion detection recording mode1080P：in the 1080P recording mode and the red light
and blue light are long on, press the mode button for 3 seconds, the red light flashes for 3
times, the blue light is long no and the red light is flashing for 3 times when the camera is
turning into the motion detection recording mode1080P, after detecting the movement of
the object, the red light and the blue light are flashing at the same time for the motion
detection recording 1080P, the recording files will be saved every 5 mins until there is no
motion or no battery or the card is full.（ press any button can exit the motion detection
Charging and recording at the same time
：
The camera will get into the 720P recording mode directly when inserting the TF card,
plug the USB-TV cable, external 5V USB power or charger (mobile power) if there is no
manual stop, the camera will keep recording until the card is full or without battery, you
can also stop recording manually and turn it into any mode.
Connect the USB-TV cable
，
if turn on the camera with the connection of TV display,
you can watch the pictures through the TV display, at the same time, you can switch to
photo taking mode, recording mode and motion detection recording mode.
When the camera crashes, the button is invalid, or cannot be used normally, you can
press the button with a sharp object to reset the insertion point
，
after resetting, the
camera can be used normally again.
After stopping the any function mode, the camera need to be powered off. Press the
ON/OFF button for 6 seconds, when all lights are off, the camera is powered off. In
standby mode without any function for 1 minute, the camera will be automatically
Time modification setting
：
The camera will automatically boot in the TF card root directory to create an TXT text
document
（
Figure
），
power off the camera and use the USB cable to connect
the computer
，
After opening TIMEREST.txt text document in Removable Disk
，
you
can Edit the time that you want, for example: format (year, month, day, minute,
second)20160804174726 Y and save the text document, and then you can turn on the
camera to record video, the video files will show the edited time. The setting without
time watermark is the same, just need to remark the tail letters Y and N. The reference
1
：
20150608192526 Y
（
with time watermark
）
2： 20150608192526 N （without time watermark）
①
Make sure that the camera has been inserted with T-flash (Micro SD) card, if
no, the double flash red and blue lights will not work properly.
②
Please keep the lens at the distance of 50 cm or more in the environment with
sufficient lighting. The picture color is naturaller, the scenery is clear and the
In power on, standby and off state, can be directly connected to the computer as U disk
using, You can freely copy, cut and paste, delete the files and format U disk
Connect to the computer USB port
，
after a few seconds the computer will pop
removable disk logo
，
the blue light will be on when identifying USB devices for data
transfer，if the red light is on, the camera is charging, and if the red light is long on, the
camera finishes charging.
1 After the product is connected to the computer, if the computer cannot recognize it, or
if the removable disk is not ejected after 30 seconds, please reset it again.
2 It is recommended to use the TF card reader to read the video file directly to play, and
directly through the USB connection to play the built-in memory video files , may be due
to the amount of data is too large, transmission cannot keep up, playback is not smooth.
Note
：
After using up the battery, it needs 2 to 3 hours to fill the battery, when the
indicator light is on, need to be charged for 30 mins more to make sure that the battery is
This product is real HD DV, so the product power consumption is larger than the
plain, and its shell material is a zinc alloy，the product is heat during using but its normal,
so you don't need to worry about the quality, we only sell the products that have been
through the long aging test to make sure to be the good quality.
Use occasions：Please strictly abide by the use of the relevant laws of the country, shall
not be used for any illegal use of this product, or it will be at your own risk
Working temperature：Please use it at natural temperature. Do not use it at
temperatures that cannot be adapted to human.
Working humidity
：
Please use in the human appropriate ambient humidity, do not put
the product in a humid working environment,This product does not have a waterproof
function, please avoid watering or exposure to rain.
Shooting requirements
：
Please use the environment in a sufficient light source, do not
put the camera directly to the sun and other light source, so as not to damage the
155-degree wide-angle lens
Built-in high-capacity lithium polymer
Sustainable recording up to 60 minutes
Windows me/2000/XP/2003/Vista; Mac Os; Linux;
Comes with system or mainstream audio and video
playback software
All manuals and user guides at all-guides.com
all-guides.com
To Next Page
Need help?
General