4.2.5 Cable
When running speaker cables it is important that good quality oxygen free cable
(OFC) is used. If the connection is with a single pair of cables, 4mm
2
speaker cable
should be used, with bi/tri wired connections, 2.5mm
2
cable should be run.
5. Technical Specification
Size (w x h x d) 485 x 612 x 320mm ( 19” x 24
1
/4
” x 12
1
/2
”)
Weight 33kgs (72lbs)
Drivers Bass cone 2 x 200mm (8”)
Mid Range 1 x 75mm (3”) softdome
High Frequency soft dome 1 x 28mm(1
1
/8”)
Maximum SPL 110dB(C)
Sensitivity 92dB at 1 watt at 1 meter
Frequency Response 45Hz-20kHz ±2dB
Nominal Impedance: 8Ω
Connectors: Triple pair gold plated binding posts for 4mm banana or
bare wire allowing connection through the passive
crossover to the individual sets of drivers
Crossover Multipole network utilizing polypropylene capacitors and air
cored inductors throughout
Power requirements Amplifier rating at 8ohm between 200-700 watts RMS
This product is built to conform to the requirements for CE marking.
Page 10
To Next Page
Loading...