My door opens out- what are my options?
We recommend placing the Flood Gate on the
inside of your door. This way you can still enter & exit
the building by stepping over the Flood Gate.
Do I have to make any alterations to the door
frame?
As long as your reveal area is smooth, you should
not have to make any alterations. If your reveal
is too small or unsmooth, you may need to add
thin spacers & use silicone caulk to level any
uneven surfaces.
Can I put these in a window frame?
Yes, as long as there is enough reveal & the window
is greater than 26in high & you can open the window
from the inside to access the back scissor jack for
tightening.
Can I install the Flood Gate with the scissor jack
facing towards oncoming water?
No, the solid outer neoprene sleeve needs to face
oncoming water. Under the sleeve are 2 steel plates
which slide when adjusting in size and then seal
against the frame structure when hit with oncoming
water, creating a solid surface. Securing this in the
opposite direction will cause these steel plates to
spread apart & cause seepage.
What if I have a ush mount door frame?
Side Rails are an optional add on & can be mounted
on the outer edge of the wall, which will hold the
Flood Gate in place. (See instruction manual for
more details)
Do Flood Gates require any maintenance?
Yes, after each use, hand wash the outer sleeve & let
dry. Wipe down the steel Flood Gate frame system
& apply a small amount of grease to all moving
mechanisms. Open & close the jack with a few
turns in each direction, allowing the grease to move
through the jack system.
Where should I store my Flood Gate?
Store Flood Gates in a nearby storage cabinet or
closet in its normal upright position. If multiple units
are stored together, be sure to place them sleeve to
sleeve, to make sure the jacks don’t get damaged
against each other.
Can I stack Floodgates one on top of the other?
No. These units were not meant to be stacked on
top of each other.
How wide is the stanchion? How wide is
a side rail?
Stanchion is 3.56in and side rails are 1.625in
Do you have a method for transporting
multiple oodgates?
Please contact Quick Dam to discuss your
specic needs.
How much width does the stanchion add?
Allow .75in in calculating width needed.
What type of tool should I use for sub-mounting
the base?”
Please refer to manual.
What if I want to create a U shape around the
door?
Use the corner stanchion to create a corner and
create a water tight seal around the door.
Can I use this in my sliding door?
Sliders typically do not offer enough depth to
t. They often jam. You can either use the corner
stanchion or side rails to create a secure area for
gates to go in outside.
Questions?
Need help?
Call:
888-761-4405
Visit:
Quickdams.com
eMail:
info@quickdams.com
To Previous Page
Loading...