Quick BK Series - Thermostat Setting

BKSeries
EN
4
5
8
INSTALLATION AND USER'S MANUAL - QUICK BK SERIES WATER Heater - REV000A
FIG.4
FIG.3
AC
NETWORK
NEUTRAL
AC
NETWORK
LIVE
TEMPERATURE
SETTING KNOB
RESET
BUTTON
4 - Installation / Use
4.2.1 - Thermostat setting
The thermostat factory-set temperature value is 60°C.
If you wish to change this value, follow the procedure below:
SINGLE-PHASE
THREE-PHASE
• interrupt the power supply.
• Remove the protection cover (4) to reach the thermostat (5) (g. 3).
• Use a screwdriver to turn the thermostat knob and set the desired temperature value (g.4).
• Ret the protection cover (4).
• Restore the power supply.
FIG.5
Turn the thermostat knob and set the desired value.
(g.5)
The thermostat regulates the water temperature only when operating with electric element.