Quick R902 - Page 7

7
GB
RRC R902/12 - REV001A
INSTALLATION - OPERATION
CONNECTION EXAMPLES
COM
SHEILD
PROG
relay 4relay 3
NO2
NO1
NO4
NO3
V + V -
relay 1 relay 2
ANT
1
COM
SHEILD
PROG
relay 1 relay 2
relay 3 relay 4
relay 5 relay 6
relay 8relay 7
relay 10relay 9
relay 12relay 11
NO1
N
O
3
N
O
5
N
O
2
N
O
4
N
O
6
N
O
8
N
O
1
0
N
O
1
2
N
O
7
N
O
9
N
O
1
1
V + V -
ANT
EXTERNAL ANTENNA
If the installation of an external antenna is required, proceed as follows:
• remove the internal antenna, made of an 8 cm long folded wire, from the
ANT input (fi g.3).
• Connect the centre core of the coaxial cable of the antenna to the ANT
input (fi g.4). The metallic shield must be connected to the SHIELD input.
• Coaxial cable during laying must not be throttled and bended at a right
angle. Must also be taken away from heat sources.
• The antenna must be installed vertically at a distance of at least 1 metre
above the boat fl oating level, away from electrical sources of disturbance
and not inside any metal structures.
• Do not install the antenna close to that of other equipment as VHF, radar,
GPS, etc.
Start-up
The receiver starts-up once the power supply is connected. After start-up, the ON/OFF LED and all display seg-
ments will light up for a short time.
Awaiting signal status
The ON/OFF LED fl ashes slowly. The receiver waits for a valid command from a stored transmitter or for confi gura-
tion.
BATTERY
FUSE **
FUSE **
* DEVICES USED IN DIRECT CURRENT
** THE FUSE VALUE MUST BE CHOSEN BASED ON ABSORPTION
OF THE USED DEVICES.
*
*
*
*
COMMON FOR THE
USED DEVICES
COMMON FOR THE USED
DEVICES
10,5-31Vdc
10,5-31Vdc
BATTERY
1A QUICK ACTING F
1A QUICK ACTING F
FIG.2
SHEILD
ANT
FIG.3
SHEILD
ANT
FIG.4
SHEILD
ANT
FUNZIONAMENTO
R902 - R904 R906 - R908 - R910 - R912
EXTERNAL ANTENNA