Quick XR Series - Installation; Installation requirements; Installation procedures

XRSeries
EN
B
45°
A
QUICK XRSeries INSTALLATION AND USER’S MANUAL - REV000A
9
4 - Installation
4.0 - Installation requirements
The windlass must be positioned by aligning the gypsy with the bow roller.
Check that the upper and lower surfaces of the deck are as parallel as possible; if this is not the case, properly compensate for
the difference (lack of parallelism could result in motor power loss).
The deck thickness must be between the values shown in the table (Sect.1). In case of different thickness, please contact your
Quick
®
dealer.
There must be no obstacles below deck for chain passage, the shallow depth of the locker could cause jams.
4.1 - Installation procedures
A) Identify the ideal position and drill the holes using the drilling template supplied.
B) Remove the excess material from the chain passage hole, nish it and smooth it with a specic product (marine paint, epoxy
resin gel) ensuring the free passage of the chain.
max 5 mm
(3/16")
minimum
1.5m (59”1/16)