Need help?Do you have a question about the Quicke Q20 and is the answer not in the manual?
General| Brand | Quicke |
|---|---|
| Model | Q20 |
| Category | DJ Equipment |
| Language | English |
Provides guidance on identifying the loader using serial numbers and plates.
Explains left/right references from the operator's seat.
General safety advice, use of approved tools, and guards.
Instructions on locating, reading, and maintaining warning decals.
Defines signal words like WARNING, CAUTION, and IMPORTANT for safety.
Explains common safety symbols used in the manual.
Details hazards and precautions to take before and during service.
Illustrates the placement of warning decals for EU regions.
Illustrates the placement of warning decals for North American regions.
Defines terms like 3rd/4th function, Q Lock, SoftDrive, etc.
Describes the Q Compact Valve for 3rd and 4th functions.
Explains the types of tool carriers and implement hooks.
Instructions for checking subframe hardware tightness and torque values.
Tables of torque values for different screw grades and diameters.
Steps for preparing the Delta subframe before mounting.
Procedures for lifting and attaching the loader to the subframe.
Steps for installing and adjusting the level indicator on the tilt cylinder.
A list of checks to perform after the loader installation.
Instructions for replacing control cables in the joystick and at the control valve.
Guidance on wiring and mounting the safety switch.
Schematic diagram of the loader's hydraulic and electrical systems.
Details the electrical connections and wiring harness for the loader.
Shows hydraulic circuit diagrams for Open Center Walvoil valves.
General causes of loader malfunction and initial checks.
A table listing problems, possible causes, and actions for loader issues.
Specific troubleshooting steps for the Compact valve.
Troubleshooting symptoms and solutions for the Electrodrive CDC system.
Table of internal leakage values for different loader models and functions.
Steps for disassembling and replacing seals in the loader cylinder.
Detailed steps for taking apart the hydraulic cylinder.
Instructions on how to replace piston seals in the cylinder.
Steps to reassemble the hydraulic cylinder after seal replacement.
General overview of the seal assembly for the hydraulic ram.
To Next Page
