PAGE 1-3
Q2 Plans - Chapter 2 - Page 2-1
BILL OF MATERIALS
TOOLS
.....There are certain tools which are necessary to complete the
aircraft. Three lists of tools are provided here. The first is the
absolute bare minimum required, sacrificing efficiency; the second is a
recommended list for the best compromise of cost and work efficiency; the
third is a list for the "Cadillac" of shops where ease of construction is
more important than money. The non-common items are stocked by Aircraft
Spruce and Specialty.
FIRST LIST - BASIC REQUIRED TOOLS
• Common household butcher knife
• Coping saw
• 1/4" drive socket set
• Small open-end wrenches
• Sandpaper.
50 sheets, 40-grit, 3M Production Paper D-wt.
50 Sheets, 80-grit, 3M Production Paper D-wt. 20 sheets, 240-grit,
3M Wet or Dry Tri-M-Ite Paper
A-wt. Silicon Carbide Waterproof.
20 sheets, 320-grit, 3M Wet or Dry Tri-M-Ite Paper
A-wt. Silicon Carbide Waterproof.
• Small Weights - Approx. 150 lbs in 5-15 lb pieces
• 6 - 6" C-Clamps
• Square and half-round files
• Pliers
• 1" putty knife
• Hacksaw
• Blade & Phillips screwdrivers
• Box of single-edge razor blades
• 24" carpenter's level
• Carpenter's square
• Felt marking pens
• 3-ft straightedge
• 12-ft decimal steel tape (Stanley #61-112)
• 1/4" drill with set of fraction and number bits,
To Next Page
Loading...