#30, #32, #10, 1/4" and #12 bits
• Taps; 1/4-28, 10-32, 1/8 NPT (Pipe Tap)
• Roll of grey duct tape
• Saber saw
• Cheap hole saw set or flycutter
• Pop rivet puller
• Homemade balance for rationing epoxy
• Wall thermometer 50 to 100°F
• 6-ft straightedge
• Small set of X-Acto knives
• Dremel-type miniature high-speed hand grinder with saw and router
bits
SECOND LIST - RECOMMENDED TOOLS
(In addition to those in the first list)
• 6" to 9" disc-type hand sander
• Set of 1/4",1/2" and 1" chisels (wood)
• 1/2"-dia 100° counter sink (piloted)
• 6" machinist steel ruler
• X-Acto razor saw
• 3/8" variable-speed hand drill
• Hand broom/brush
• Bench-mounted belt sander
• Stanley surform plane
• Vacuum cleaner (shop type)
• Dovetail saw
• Epoxy Ratio Pump
• Plumb bob
THIRD LIST - FOR THE FIRST CLASS SHOP
(In addition to those in the first and second list)
• Drill press
• 18-inch band saw
• Vernier Caliper
• 90° drill adapter
• Air compressor with blow nozzle
• Orbital sander
• NICO press sleeve tool
• Clecos - one dozen 1/8"
• Hotwire Voltage Control
ITEMS USED ONLY OCCASIONALLY AND CAN BE BORROWED
• 1 dozen 1/8" Clecos
• Hotwire Voltage Control
To Next Page
Loading...