for soldering) and starts to stop heating after 120 seconds, and it will
automatically heat when picked up.
When the menu is in "Sleep Off", it means that it is turned off and
automatically detects whether there is a worker using it, and the
soldering iron will always be in a heating state.
When the menu is in "Off Screen On 60", it means that the screen
will be turned off for 60 seconds after the button is not operated, and
the screen will automatically light up when the button is operated.
When the menu is "Off", the display will keep displaying.
This menu indicates whether the quality of the power supply is stable.
If the power supply is unstable, the value can be adjusted
appropriately. I f the main menu shows insufficient power, it is
recommended to replace the power supply.
When you select "Language" and enter CHS ENG select the
appropriate language for display according to your needs.
When this menu is selected and the OK button is pressed, it will return
to the main interface of temperature display
Pow er selection:
DC power supply DC12~ 24V. The higher the voltage, the higher the
current is at 24V and the lowest 3A, and the faster the heating speed.
On the contrary, the lower the voltage, the lower the current is at
least 1.5A, and the heating speed is slightly slower. Power selection
as shown below.
To Next Page
Loading...
