Quicksilver 905WE - Page 39

27
Quicksilver 905WE — System & Component Overview and Operaon
Operaon
Each me a sink is used, the water drains either into the grey water tank by gravity, or it drains into a
sump pump which pushes the water in to the grey water tank. On your boat, galley sink drains via
gravity to the grey water tank, while the head sink and shower drain goes to a sump pump.
Tank Level
Located in the baery switch panel tub, there is a gauge for reading the level of uid in the holding
tank. To see how much uid is in the holding tank, press the momentary switch towards Tank 2.
Dockside Pumpout
The dockside pumpout deck plate is located on the starboard side under the LPG storage lid, and is
marked with the ISO symbol WASTE. The grey water deck plate is located on the INBOARD side, next
to the waste deck plate. The dockside facility will have the proper connecons / ngs to pump the
grey water tank out.
Macerator (oponal)
The oponal macerator gives the boat operator the means of discharging the grey water tank directly
The dockside pumpout deck plate does not have a chain
connecng the cap to the deck plate. Use cauon not to
drop the deck plate cap into the water.
Grey Water System with Oponal Macerator Discharge
Head sink drain
Shower drain
Shower sump pump
Galley drain
Greywater tank
Tank vent thru hull
Tank pumpout hose
Pumpout deck plate
Macerator
Macerator thru-hull
Macerator switch
When the baery switch is in the OFF posion, the sump
pump does not work. Any liquids poured down the head
sink or shower drain will not be pumped to the grey water
tank.