BOTH ASSEMBLIES USE THE SAME HARDWARE
At this point, both wings are attached to the Trike and the Trike is sitting on all three wheels.
First step is to set the Tail Skid on blocks (chair) and attach the Upper Tail Booms to the
Channels on the Wings. You will need to Rotate the channels to align with the holes in the
Boom Tube. Raise or Lower the tail skid as needed. A 1/4” drift pin (or Phillips Screw Driver)
will aid in this step. CAUTION: Be very sure the Upper Boom Tube aligns easily to Channel.
Once connected DO NOT raise or Lower the tail assembly. This will damage Tubing, Channels
and or Bolts.
and or Bolts. Attach the AFT end of the Lower Boom Tube to the bottom of the Tail Skid (41150)
Attach the FWD end of Lower Boom Tubes to the Channels on the Main Axle.
Attach the Landing Gear Side Wire to the Tang on the Main Axle.
CHANNEL (20090)
TAIL BRACE TUBE
(40425)
UPPER BOOM TUBE
(40179)
WING TRAILING EDGE
MAIN AXLE
AN4-20a
(10170)
WASHER
LANDING GEAR SIDE WIRE
(20616)
1/4” LOCKNUT
(10510)
LOWER BOOM TUBE
(40421)
TAIL GROUP TO AXLE & WINGS
To Next Page
Loading...