LEADING EDDLE UPPER WIRE TEMPLATE
SLOT
FROM CENTER OF SLOT TO CENTER
OF BOLT HEAD IS APPROX. 9-3/4”
1. REMOVE TEMPLATE FROM MANUAL
2. CAREFULLY CUT OUT “SLOT” AND HOLE #1
3. ALIGHT HOLE #1 ON COMPRESSION STRUT BOLT HEAD
4. ALIGN “PERPEDICULAR” AND “PARALELL” EDGES WITH LEADING EDGE SPAR
5. TAPE TEMPLATE ONTO PLACE
6. MARK “SLOT” ONTO WING COVER
7. REMOVE TEMPL
7. REMOVE TEMPLATE FOR USE ON OPPOSITE WING
8. HEAT CUT SLOT IN WING
To Next Page
Loading...