TIP STRUT ATTACHMENT
12-3/4”
WING TRAILING EDGE
TIP STRUT
(40410)
3/8”
OFF VERTICAL
COMP
STRUT
BETTER TO CUT STRUT
TO LONG AND MAKE
ADJUSTMENTS.
PULL OUTBOARD RIB
WHILE PUSHING COMP STRUT
DRILL 3/16” Hole
File Fish Mouth in the end
of the Strut. File be should
Parallel with Rib
COMP STRUT (40283)
TIP STRUT
(40410)
Flat end
of Strut
AN3-17a
(10050)
Using Tip Strut as a guide, drill 3/16” hole
12-3/4” from front of Comp Strut. VIEW “A-A”
Loosly attach Strut as to get a measurement
on where to cut the end & Fish Mouth.
Ideally help is available.
While pulling on Tip Rib & Pushing on Comp Strut
ma
make a mark on the Strut
Using Rat Tail File shape end as shown. Better
to have strut to long and make adjustments to fit.
Heat Cut Fabric in area where Tip will push on Rib
Be carefull not to cut thru Wing fabric.
Once installed there will be some slight
“Bowing”of the Compression Strut.
Thats OK.
Thats OK. Tension will hold Tip Strut in Place.
To Next Page
Loading...