PEDAL MOUNT TUBE
(40430)
1“ X 1/4”
SADDLE
(20280)
1/4 Washer (10560)
1/4” Locknut (10510)
LEFT PEDAL SHOWN
6-7/8”
(17.5cm)
1/2” 1/2”
Clevis Pin (10440)
FOOT PEDAL & RUDDER CABLE ASSEMBLY
Safety Ring
(20310)
Clevis Pin (10440) thru this 3/16” hole to
attach to top of Spring (91115)
See Note on page 6-5
Non Skid Tape (20190)
Trim as shown.
1/4” Locknut
(10510)
Drill 1/4” (6.3mm) using dimensions below
After Pedals are installed, a TIE WRAP (30480)
used as spacer between pedals bushings.
Foot Pedal (70231)
To Next Page
Loading...