3/16” Washer
(10550)
THROTTLE ASSEMBLY
Assemble the Lever 90202) to the Mount (90201).
The Throttle Cable will be installed during Engine
install. The Forward Shoulder Bolt (90300) sets the
Forward STOP for the Throttle Lever.
IDEALLY ATTACH THIS ASSEMBLY TO SEAT AFTER
STEPS ON PAGE 8-9. In some instance there is
interference with the Push Pull
interference with the Push Pull Tube (40177)
Sould be mounted as low as possible on seat.
SWIVEL MUST ROTATE FREELY
Supplied with
engine package
NOTE: Tighten Castle Nut until desired friction is obtained.
Secure with Safety Ring thru slot in nut and hole in bolt
.
To Next Page
Loading...