Install a barrier's safety system that complies with current regulations. Choose short routes for cables and
keep power cables separate from control ones. Install the control card in a waterproof box. Please refer to
current regulations when setting the gear motor’s maximum torque. We advice you to install an outdoor
switch, in compliance with European standards on the issue of safety, to turn the electricity off when
servicing the barrier. Check that each single installed device is efficient and effective. Affix easily
readable signs warning about the presence of a automatic barrier.
USE
It is absolutely forbidden to use the device for any other purposes (e.g. lifting of persons or things) other
than those foreseen. The manufacturer holds no responsibility what so ever for damages caused by said
actions. The installed electronic unit (which must have built-in electric friction), allows to select the following
functions:
- automatic: one
control impulse will open or close the barrier;
- sem
i-a
utomatic: one control impulse will open or close the barrier.
In case of a blackout, manual operation is possible by activating the unlocking device.
Having an automatic and electric power device requires special attention in a few situations:
- do not allow children to play with the appliance or its controls, including remotes
- the appliance is not to be used by persons (including children) with reduced physical, sensory or
mental capabilities or lack of experience and knowledge, unless they have been given supervision or
instruction;
- not to touch the device with wet hands and/or wet or bare feet;
- to turn off electricity before opening the control box and/or actuator;
- to put the automatic barrier in movement only when it is completely visible;
- to keep out of the barrier’s range of action if it is moving. Wait until it has stopped;
- not to let children or animals play near the barrier;
- not to let children use the remote control or other operating devices;
- not to let children play with fixed controls;
- to carry out routine maintenance;
- in case of failure, to turn off electricity and operate the barrier manually only if it is possible
and safe. Refrain from touching the barrier and call an authorised technician.
- when operating a biased-off switch, make sure that other persons are kept away
- frequently examine the installation for imbalance and signs of wear or damage to cables, springs and
mounting· Do not use if repair or adjustment is necessary
- not to pull the cable to disconnect the equipment;
- not to perform the automatic and semi-automatic function in the presence of known or suspected
malfunctions;
- not to rest against the bar or the cabinet for any reason, even when the barrier is inactive;
WARNING: IMPORTANT SAFETY INSTRUCTIONS
It is important for the safety of persons to follow
these instructions. Save these instructions and
keep them together the technical documentation
for future reference.
WARNING: The drive shall be disconnected from
its power source during cleaning, maintenance
and when replacing parts
To Next Page
Loading...