Page 10
Chin Strap fit
D-Rings (Quin McQ)
Quick Release strap (Quin Spitfire & Quin Ghost)
Position the straps underneath your chin, towards your
neck, and secure the D-rings. Tightly fasten the chin
strap by passing the end of the strap through the D-rings,
as shown in Figure A, then pull it comfortably tight for
a secure and snug t. The strap should be as tight as
possible, but without causing pain.
To remove the helmet, pull the D-ring tab outward to
release the strap tension as shown in Figure A and then
unthread the chin strap. Pull the staps outward, rotate
your helmet forward and lift it off.
IMPORTANT: Make sure that you always fasten the
chinstrap securely beneath your chin when wearing the
helmet.
The Quin Design helmets comes with two types of chin
straps: D-rings in Quin McQ and Quick release strap in
Quin Spitre and Quin Ghost.
Position the straps underneath your chin, towards the
neck. Tighten the strap on Ratchet tab almost as close
as possible, then slide the tab under the Ratchet catch
and adjust as necessary for a tight,secure t, as shown
in the Figure B.
To remove Pull the red strap on the Ratchet
catch for a Quick Release.
Figure A
Figure B
To Next Page
Loading...