Safetv Labels/Decals
,---
tWA_RN~GI
Removal or painting over safety labels will result in
uninformed conditions. This may result in personal
injury or property damage. Warning signs and
labels shall be provided with enough light to read,
conspicuously located and maintained for legibility.
Do not remove any warning, caution, or instructional
material attached!
Instruction Manual
iWA~~GI
Provisions should be made to have the instruction
manual readily available to the operator and
maintenance personnel. If, for any reason, any part
of the manual becomes illegible or if the manual is
lost, have it replaced immediately. The instruction
manual should be periodically read to refresh one’s
memory-it may prevent a serious accident.
Induction Svstem
“...
Extreme care must be taken in selecting a proper
induction filtration system for the vacuum pump.
Liquids, solids and abrasive powders can result in short
life or mechanical failure of the bearings, erosion of the
rotors, plugged fluid filter and/or separator element,
short life of the fluid seal, corrosion of internal parts
and motor overload. Use a vibration isolator and
support all piping correctly. Piping size should beat
least as large as the inlet valve opening. The piping
must be leak free and absolutely clean after fabrication.
All connections to the vacuum pump must be tight. Air
leakage into the vacuum system lessens the vacuum
pump’s ability to draw down to a base level of vacuum
and increases energy consumption.
“’’gNut——————.
End CaP —
>~”
Filter ~
Element
❑
~ clean
+
Housins Lid —
Mounting
\
Clean
Stem
Hous~
T
Do Not Let Debris
Fall Into i%lllp
Clean Out Schematk “L” Type Filter
Housing
Mounbns
v
-’---=. ~,m
Stem
:::.t.b’”
~—
clean
M@ Nut .d ~=
Washer
Carustel
u
Clean Out Schematic:
“T” Type Filter
Page 38
.——. —— .—. —... =—
—..._—
——m -..—..-.—.—. -. — —-
——.—-n —m . . ..-
. . . ..—.—
To Next Page
Loading...