Quincy Compressor QSVI Series - Page 70

.
,-. .
Installation Instructions
1. Install SAE O-ring on port end of fitting.
2. Make sure both threads and sealing surfaces are free of burrs, nicks and scratches,
foreign material.
3. Lubricate O-ring with light coating of QUINSYI@.
4. Tighten fitting securely to port.
NOTE: 1. For steel
2. Restrain
housings.
fittings in aluminum, cast iron, or steel
fitting body on adjustables if
necessary in installation.
*
SAE Straight ‘Thread O-Rhg Fitting (AdjustaMe):
Assembly, Fitting to Port
1
w
M9LE
O-RING
PORT END
or any
SEfl_ I NG
SURFf?CE
FEt4fW_E
O-RING
PORT
1, Install O-ring cmfitting. DO NOT nick the O-ring.
2. Inspect both mating surfaces for burrs, nicks, scratches or any foreign particles.
3. Lubricate O-ring with light coat of QUINSW.
f )
SEfILING
[
THRE9D HERE
FOR HOLDING
POWER ONLY
<RESISTING
PRESSURE BLOWOUT )
Page 66
.._..,. __.. ——. —.._
—.
.-—..—---
—.-...—...-.-.———. ——.._
—-