AROS|
DONOTOPERATEINFREEZINGOUTDOORCONDITIONS
This air conditioner was not designed for and should not be
used in freezing outdoor conditions.
COOLMODE
Use the Cool mode at Low, Med, or High for cooling. Use the
Temperature Increase / Decrease controls to set the desired
temperature between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off to keep the
room at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler. Set the thermostat
at a higher number and the indoor air will become warmer.
NOTEIf Aros is off and is then turned on while set to a cool
setting or if turned from a fan setting to a cool setting, it may
take approximately 3 minutes for the compressor to start and
for cooling to begin.
COOLINGDESCRIPTIONS
For normal cooling-SelecttheCoolmodeand
HighorMedfanwithamiddlesettemperature
For maximum cooling-SelecttheCoolmode
andHighfanwithalowersettemperature
For quieter and nighttime cooling-Selectthe
CoolmodeandLowfanwithamiddlesettemperature
ECOMODE
This mode optimizes the cooling power of your air conditioner,
thereby saving you energy. Once the set point temperature
has been reached, the fan will cycle off to save energy. The fan
will cycle back on periodically to ensure all cooling capacity in
the system is used. This mode is the default mode for the unit.
Each time the unit is powered off, it will restart in Eco mode ON.
The first time the unit is turned on, the settings will be 70° and
Low fan. You can adjust the fan speed and temperature to your
personal comfort.
EcoONhelpsminimizeelectricityuseItisnormalforthefan
tocycleoffandthenbackoninthismodeThison/offcycle
canrepeatmultipletimesBecausethefanwillcycleoff
youmaynoticeavariationinroomtemperatureandhumidity
EcoOFFWhenthismodeisnotengagedthefanwillrun
continuouslyandinCoolmodethecompressorwillcycleon
andofftomaintainroomtemperature
FANONLYMODE
Use the Fan-only mode at Low, Med, or High fan speed to provide
air circulation and filtering without cooling. Since Fan-only
settings do not provide cooling, a set temperature cannot be
entered. The room temperature will appear in the display.
POWEROUTAGERECOVERYFEATURE
In the case of a power outage or interruption, the unit will
automatically restart in the settings last used aer the power
is restored.