EasyManuals Logo

Quooker Nordic Square User Manual

Quooker Nordic Square
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
1
3 4
HOT
COLD
2
B
1 Fitting tap
Push the supplied inlet hoses through
the black plastic insert and connect
the hoses to the base of the mixer
tap. Push the hoses through the hole
in the work top.
2 Securing tap
Position the brass xing plate around
the hoses. Screw the xing nut onto
the tap thread. Adjust the position of
the tap to ensure that the Quooker logo
is facing the user. When the handle is
in the cold position, it will be parallel
to the edge of the work top. Tighten
the xing nut with a pipe wrench,
socket wrench or spanner.
3 Fitting to thin work top
When tting to a thin work top, use
the white tap support.
4 Connect hoses
Insert the inlet hose screens and connect
the hot and cold water inlet hoses to
the hot and cold water supply.
Fitting tap
When fitting the tap into an existing 32 mm hole, use the black rubber washer instead
of the plastic insert.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quooker Nordic Square and is the answer not in the manual?

Quooker Nordic Square Specifications

General IconGeneral
BrandQuooker
ModelNordic Square
CategoryMixer
LanguageEnglish