FFLED18 EMERGENCY INSTALLATION SHEET
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
RAB xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF and batteries are DISCONNECTED before installing or maintaining xture.
No user serviceable parts inside.
Thank you for buying RAB lighting xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com
Housing
Screws
Bracket Screw
Emergency
Batteries
Back Box Housing
Gasket
FFLED18/E
Battery
Connector
Gasket
Screws
Bracket
MOuNTING
CAUTION: Suitable as Wet Locations as Wall Mount.
1. Loosen and remove (4) Screws and separate Back
Box from Emergency Housing. Use provided tether.
2. Drill necessary holes on Back Box. Measurements
of drill positions are shown below.
3. Match the hole pattern and place the Gasket on the
Back Box.
4. Secure the Back Box on the surface with hardware
appropriate for the mounting surface.
5. Wire the xture to the incoming supply wires
according to NEC and local codes. Use UL listed
wire connectors.
6. For FFLED18/E, each battery unit has one
connector. For FFLED18/EC, each battery unit has
two connectors as shown below. For details refer to
the appropriate Wiring Diagram section and supplied
Instruction Sheet.
7. Connect the battery connectors. DO NOT connect
the Batteries before wiring the xture to the supply.
8. Secure Housing to Back Box. Check Housing
Gasket seal all around.
9. Apply sealant to all unused conduit entry points.
To ensure weatherproof seal, apply weatherproof
silicone sealant around the edge where the xture
meets the wall. Seal arm thread using teon tape or
silicone sealant.
Two connectors for
FFLED18/EC
To Next Page
Need help?
General
