Need help?Do you have a question about the RAB Lighting los 2500 and is the answer not in the manual?
General| Brand | RAB Lighting |
|---|---|
| Model | los 2500 |
| Category | Accessories |
| Language | English |
Lights stay on as long as motion is detected. They turn off a short time after motion stops. Adjustable from 10 secs to 15 mins.
A 6" wave of a hand or head tilt once every 15 minutes is sufficient to keep the lights on.
Separate sensor and HVAC register by at least 4' to prevent turbulence from causing false activation.
Diagram showing connections for power input and light output for sensor installation.
Steps for placing the sensor in the circuit, connecting wires, and mounting.
Adjusting the photo control to keep lights on during sunny days or operate only during low light levels.
Adjusts the delay time from 10 seconds to 15 minutes for lights to turn off after no motion.
Reduces detector sensitivity by 5%, useful for smaller rooms or to avoid false triggers.
Restricts the sensor's detection zone by covering portions of the lens to avoid unwanted areas.
Allows up to an hour for the sensor to reach room temperature after transit for normal operation.
Checks for obstructions, bulb/fixture function, power, and increasing sensitivity.
Checks for motion, IR sources, adjacent room detection, and voltage.
Checks for issues listed under 'Lights Do Not Turn Off' sections 2, 3 & 4.
Specifies the coverage area as 2152 sq ft at 9' height for both models.
Details incandescent and fluorescent wattage limits for LOS2500/120 and LOS2500/277 models.
Lists horsepower ratings and the adjustable time delay range for the sensors.
Covers replacement or repair for defects within one year of purchase.
Procedure and cost for repair or replacement of units out of warranty.
To Next Page
