Assembly Instructions for ProRak Series Workstations
Part List
1. Legsx4
2. Span Braces 2 long (back span), 2 short (sides)
3. Wing nutx8
4. Complimentary 10-32 rack screwsx8
Instructions:
1. Start by removing the outer packaging. Begin and complete the assembly with the
unit resting in the base of the packaging.
2. Simply screw the numbered legs onto the matching numbered mounting plate
attached to the underside of the workstation.
3. Attach the span braces to the pre-positioned brackets on the legs using the wing
nuts.
4. Lift your workstation onto its legs and remove the remainder of the packaging. You
are ready to load your gear.
1507 S. Olive St. South Bend, In. 46619
www.rabaudio.com
To Next Page
General