Step 1
Remove the faceplate by unthreading all 4 bolts counter-clockwise with a 4mm hex wrench.
Step 2
Slide the stem onto the steerer and position it against the headset or spacers. Orient the stem so that the logo and laser
etching are the correct way up.
WARNING: Incorrect stem and/or spacer configuration, too high or too low, can lead to damage of the steerer
or stem, or result in unwanted movement from the stem, which can lead to component failure, a crash, and
SERIOUS INJURY and/or DEATH. For more information, consult your fork/headset manufacturer, a qualified
bicycle service technician, or raceface.com.
To Next Page
Loading...
