Racer SUCCESS - User Manual

Questions and Answers

E
Elizabeth HallAug 8, 2025
What to do if Racer SUCCESS Swimming Pool Vacuum cleaner does not reach all pool area?
- M
  Melissa MooreAug 8, 2025
  If your Racer Swimming Pool Vacuum isn't reaching all areas, several factors could be at play. First, ensure the power supply is properly positioned to allow the cable to reach every part of the pool. If algae is present, clean it before using the cleaner to prevent it from floating and hindering the process. For irregular pool shapes, focus the robot on areas needing specific attention. Also, turn off the pool filter system and pump during operation. Finally, make sure enough cable is released into the pool.
E
Eugene TaylorAug 16, 2025
Why Racer Swimming Pool Vacuum cable twists or coils up?
- B
  Brandon HallAug 16, 2025
  The Racer Swimming Pool Vacuum cable might twist or coil due to a few reasons. There could be an obstruction in the pool that's tangling the cable; remove any obstructions you find. Alternatively, the cable could be stuck on the main drain outlet; if so, turn off the pool filter system. Also, if the cleaner has been working for too long, manually release the cable.
K
kurt26Aug 22, 2025
What to do if Racer SUCCESS Swimming Pool Vacuum just sits at the bottom of the pool?
- E
  Eileen WilsonAug 22, 2025
  If your Racer Swimming Pool Vacuum remains stationary at the bottom after several passes, check the power supply for flashing LED indicators, which may signal completion of the default 1-hour cleaning cycle. Try resetting the cleaning time to 1H, 2H, or 3H. Also, a blockage in the filter tray could be the issue; clean the filter tray and then restart the machine.
J
Jennifer WhiteAug 30, 2025
How to release Racer SUCCESS cable?
- B
  Brittany Smith PhDAug 30, 2025
  To release the cable of your Racer Swimming Pool Vacuum, unplug the power cord and then release the cable.