d. READ --- SCANNER:
Track/driver frequencies, names, codes and channel numbers could be uploaded to PC or destination
scanner though a cable from source scanner.
• Upload data to PC: Connecting USB interface cable to the source scanner, and move cursor
to Read Channel Table on PC and slick it twice to upload data from scanner (Radio Î Read
Channel Table Î Waiting for Channel Table would show on pop window). Set scanner to
READ ---SCANNER function (PROGRAMMING Î READ----SCANNER Î SELECT Î
ENTER Î Transmitting shows on the display). PROGRAMMING COMPLETE will show on the
display of the scanner when it ends.
• Cloning data to destination scanner: Connecting clone cable to the destination and source
scanners, Set destination scanner to WRITE ---SCANNER function (PROGRAMMING Î
WRITE----SCANNER Î SELECT Î ENTER Î Receiving shows on the display).And set
source scanner to READ----SCANNER function (PROGRAMMING Î READ----SCANNER Î
SELECT Î TRANSMIT Î Transmitting shows on the display during source scanner
transmitting data to destination scanner). PROGRAMMING COMPLETE will show on the
display of the source scanner when it ends.
e. RACE SERIES:
Select RACE SERIES to view bank names, select the bank name and use the Numeric Key Pad to
enter letter/number into it.
f. RESET SCANNER:
Scanner will return to default setting and clear the voice record if RESET SCANNER command is
performed.
FCC Warning:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Modification of this device to receive cellular radiotelephone service signals is prohibited under FCC
rules and federal law.
To Previous Page
Loading...
