Need help?Do you have a question about the Rackable Systems OMNISTOR 4000f SERIES and is the answer not in the manual?
General| Form Factor | Rack-mountable |
|---|---|
| Management | Web-based management interface |
| Drive Type | SATA |
| RAID Support | RAID 0, 1, 5, 6, 10, 50, 60 |
| Power Supply | Redundant |
| Cooling | Redundant Fans |
Visual overview of OmniStor 4000F Series Storage System components.
Detailed description of major system components.
Details the front bezel, its LEDs, and access to drives.
Information on AC and DC hot-swappable power supplies.
Describes the cooling fan module and its monitoring.
Information on the SES Controller Card for monitoring and configuration.
Details the Disk I/O Card for Fibre Channel connectivity.
Explains enclosure monitoring via LEDs and system controls.
Describes front bezel LEDs for system status.
Explains Drive Status and Activity LEDs.
Discusses the audible alarm for abnormal conditions.
Overview of JBOD topology and its two operating modes: split bus and single bus.
Details the Split Bus Dual-Loop Mode for JBOD configurations.
Discusses supported copper and optical media types for Fibre Channel connections.
Introduces procedures for installing and setting up the OmniStor 4000F Storage System.
Guides through hardware installation, cabling, and topology configurations.
Step-by-step instructions for rack mounting the storage system enclosure.
Step-by-step instructions for installing the storage system in a tower stand.
Final steps for physical installation, including disk drive and bezel attachment.
Prepares for the next sections on configuration and cabling.
Instructions for Windows 2000 installations regarding driver setup.
Covers front bezel LEDs and the "One-Touch Annunciation" system for status.
Describes front bezel LEDs for system status.
Explains Drive Status and Activity LEDs.
Discusses the audible alarm for abnormal conditions.
Describes the press-to-touch display for SES Controller, fan, and I/O settings.
Details accessing the enclosure's monitoring via a VT-100 terminal.
Allows monitoring of read/write command buffers for SES processors.
Procedures for updating the SES Controller card firmware.
Explains software control for fan speed, including whisper mode.
Solutions for common issues like power failure and non-responsiveness.
Troubleshooting for issues related to cabling, transceivers, and speed settings.
Explains common symptoms and LED indicators for faults.
Addresses issues with terminal emulator communication and settings.
Covers issues encountered during Power On Self-Test (POST).
Steps to unlock and remove the front bezel for access.
Procedure for replacing the hot-swappable cooling fan module.
Steps for replacing a hot-swappable AC power supply.
Steps for replacing a hot-swappable DC power supply.
Procedure for replacing a disk drive, including ESD precautions.
Steps for removing and replacing the hot-swappable Disk I/O Card.
Procedure for replacing the SES Controller Card, requiring power down.
Instructions for replacing the entire storage system enclosure.
Technical specifications for the OmniStor 4000F Storage System.
Details the RS-232 service port for monitoring and firmware updates.
Information on the DB-9 female-to-female null-modem cable.
Description of SFP transceivers used in Disk I/O cards and safety notes.
Manufacturer's declaration of conformity with FCC Part 15.
Statement regarding compliance with FCC Class A device limits.
Regulatory statement for Class A devices in Taiwan.
Regulatory statement for Class A devices in Japan.
Indicates compliance with European Community directives.
Guidelines for selecting appropriate power cords for different regions.
To Next Page