Raco Verbatim - Remote Supervisory Control (VRSC) Output Installation and Operation Instructions

Remote Supervisory Control Output
Verbatim Owner's Manual C-1
1234567890123456789012345678901212345678901234567890123456789012123456
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1
23456789012345678901234567890121234567890123456789012345678901212345
6
1234567890123456789012345678901212345678901234567890123456789012123456
a
1234567
1
23456
7
1
23456
7
1
23456
7
1
23456
7
1234567
C Remote Supervisory Control Output
C.1 Remote Supervisory Control (VRSC)
Output Installation and Operation
Instructions
This option allows you to turn connected equipment on and off from any remote
Touch Tone telephone, or from an non-Touch Tone telephone with the use of a
portable tone generator. Option VRSC-4 provides 4 outputs, VRSC-8 provides
8 outputs. The unit’s voice guides and confirms your operations. Advanced
features such as programmable length momentary activations are included.
Control operations may also be performed from the unit’s keyboard.
Connections are normally made by means of optically isolated solid state relays
housed in a separate Output Relay Enclosure which requires its own 120 VAC
power connection. In some situations, the user may choose to make
connections directly to the transition outputs within the main unit.
If your unit was not originally equipped with this option, refer to the separate
instructions for adding this option.
C.1.1 Mounting and Wiring Connections for Remote
Supervisor Control
If you are using the separate Output Relay Enclosure normally supplied with
this option, mount the enclosure within 3 feet of the Verbatim Autodialer, and
make your output connections to the left hand row of terminal strip points
within the separate enclosure, as shown in the diagram of the VRSC Output
Relay Enclosure. Be sure that the correct type of plug-in Opto 22 relays are in
place. The available types are:
Type Value
OAC5 12 to 140 VAC, 2 amps
OAC5A 24 to 280 VAC, 2 amps
OAC5A5 120/240 volt AC, Normally Closed
ODC5 5 to 60 VDC, 2 amps
ODC5A 5 to 200 VDC, 2 amps
ORR 5 Reed relay dry contact output