Raco Verbatim - Time and Date Setting; Printout at Regular Intervals

Printer Options
D-2 Verbatim Owner's Manual
u To activate this port, attach a RACO VPPC-1 Parallel Printer Cable (or
equivalent) to the front panel port and to the parallel port on your printer.
I Caution:
Attach the parallel printer cable to the VSS front panel port with the “red
striped edge” on the right side. If you connect any other way, you may
damage the parallel connection on your printer.
D.1.3 Time and Date Setting
Time and date may be set or corrected with the following programming code
entries:
u To check the date
941 ENTER
u To set the date
941 MM DD YY D ENTER
where:
MM is the month (03 for March)
DD is the date (07 for the 7th day of the month)
YY is the year (89 for 1989)
D is the day of the week (1 for Sunday, 2 for Monday, etc.). Entry
of D is optional.
u To check the time
942 ENTER
u To set the time
942 HH MM SS ENTER
where:
HH are the hours in military time (13 for 1 PM)
MM are the minutes (09 for 9 minutes)
SS are the seconds. Entry of SS is optional.
u To clear the time and date back to 00:00:00 on 01/01/89.
935 7 ENTER
D.1.4 Printout at Regular Intervals
The unit may also be programmed to automatically log (printout) all input
conditions at regular intervals, by entering code: