Verbatim Autodialer Specifications
I-2 Verbatim Owner's Manual
I.2.2 Permanent Resident Non-Recorded Messages
Permanent built-in messages shall be included to support user programming
operations, to provide supplemental warning messages such as advising that the
alarms have been disabled, and to allow the unit to be fully functional even
when the installer has not recorded any messages of his own.
I.3 Local & Remote Programming
Capabilities
The user may optionally elect to alter the following parameters from their
standard normal default values via keyboard entry or remotely from any Touch
Tone phone.
Capability Setting/Description
Alarm Call Grouping On alarm, system shall selectively call the
correct phone numbers according to the
current alarm(s).
Alarm response delay .1 to 9999.9 seconds.
Delay between alarm call outs .1 to 99.9 minutes.
Alarm reset time: 0.1 to 99 hours or “NO RESET”.
Incoming ring response (answer) delay 1 to 20 rings.
Input alarm criteria Each channel shall be independently
configured for “Normally Closed,”
“Normally Open,” “No Alarm," or
"Disabled."
Autocall Test When enabled, the unit shall place a single
round of test calls, both at the time this
function is enabled and also at regular
subsequent intervals until this function is
disabled at the keyboard.
Run Time Meter Selected physical channel inputs shall
accumulate and report the number of hours
that its input contacts have been closed.
Remote system microphone activation.
Remote and local arming and disarming
of system.
Pulse Totalizer Function. Selected physical input channels shall be
capable of counting pulses of up to 100Hz.
at 50% duty cycle.
To Next Page
Loading...
