Raco Verbatim - Page 222

Worksheets
J-22 Verbatim Owner's Manual
Worksheet C Message Planning & Recording Calculations:
Total estimated recorded message length in seconds, page 11 of 11 ________
Total estimated recorded message length in seconds, page 10 of 11 ________
Total estimated recorded message length in seconds, page 9 of 11 ________
Total estimated recorded message length in seconds, page 8 of 11 ________
Total estimated recorded message length in seconds, page 7 of 11 ________
Total estimated recorded message length in seconds, page 6 of 11 ________
Total estimated recorded message length in seconds, page 5 of 11 ________
Total estimated recorded message length in seconds, page 4 of 11 ________
Total estimated recorded message length in seconds, page 3 of 11 ________
Total estimated recorded message length in seconds, page 2 of 11 ________
Total estimated recorded message length in seconds, page 1 of 11 ________
Total estimated recorded message length in seconds, all pages ___________
See Code 912 for alternate method of timing spoken messages.
 Note:
For any channels that you have programmed for Status Report Only or for
Run Time Metering, the message to be spoken on Open Circuit input is
recorded with the Program Code ordinarily used for the Alarm Message;
the message to be spoken on Closed Circuit input is recorded with the
program code ordinarily used for the Normal Message.