Raco Verbatim - Annunciator Sequence Option Summary

Annunciator Sequences and Options
Verbatim Owner's Manual K-5
K.4 Annunciator Sequence Option Summary
The following paragraphs provide a concise summary of the available
annunciator sequence options. The ANSI designator is given, along with the
Verbatim configuration code, followed by a short functional description.
M-1: Manual Reset with Silence Pushbutton.
Code (923 1)
Alarm states are registered directly from configured criteria without regard for
return to normal conditions. Alarm states are locked in and dialer will continue
to call until acknowledged. Acknowledged alarms are reset via automatic timer.
Total dialer reset andsilence via arm/disarm key.
M-1-5-6: Manual Reset with Silence Pushbutton, No Flashing, and No
Audible.
Code (923 1) - with no phone numbers programmed
Same as M-1, except the alarm state is immediately converted to acknowledged
state.
A-1: Automatic Reset with Silence Pushbutton.
Code (923 3)
Same as M-1 except the acknowledged alarm state will be cleared if the channel
returns to normal. The check for this transition occurs only when all alarms
have been acknowledged.
A-1-5-6: Automatic Reset with Silence Pushbutton, No Flashing, and No
Audible.
Code (923 3) - with no phone numbers programmed.
Same as A-1, except the alarm state is immediately converted to the
acknowledged state.
A-1-4: Automatic Reset with Silence Pushbutton and No Lock-in.
Code (923 2)
Same as M-1 except BOTH the acknowledged and unacknowledged alarm
states will be cleared if the channel returns to normal. The check for this
transition occurs only in between alarm calls.
A-1-4 variant: Automatic Reset with Silence Pushbutton, No Lock-in, and
Single Acknowledge Report.
Code (923 4)
Same as A-1-4 except the clearing for the acknowledged alarm can't happen
until after a single report has been made.