Raco Verbatim - Page 241

Verbatim Owner's Manual Index-5
Index
codes 1-2, 6-1
dialing delay 5-5
input channels 3-3
local and remote specifications I-2
offset factors B-3
omitting a field F-6
phone numbers 3-2, 6-14, J-2
phone numbers to channels 6-21
printing 2-7
real world method B-5
report status 3-3
resetting operations 3-1
review mode 5-5
scaling factors B-3, B-4
system specific method B-5
voice 1-1
Public Address Broadcast I-6
Pulse
selection 6-16
Pulse Totalizer
inputs I-2, I-4
codes 6-12
Pulse/Tone
automatic selection 6-18
dialing codes 6-4
R
radio transmitter
connecting H-12
RC
alarm criteria F-3, F-13
commands F-5
criteria-based alarms F-8
digital, analog F-3
linkage configurations F-15
Linking F-15
polling F-19
programming F-5
programming key sequences F-6
remote message recording F-12
Status F-10
status over phone F-3
RC (Remote Channel) F-1
real world method
programming B-5
REARM
delay 6-26
key 3-4
reading, setting time 7-7
setting date 7-7
recording
alarm relay H-7
extending individual messages 4-5
messages 4-1, 4-4
setting rate 4-5
speech times H-5
relay, alarm H-7
remote alarm monitoring 1-1
Remote and Local Programming I-2
Remote Channel (RC)
pre-configured F-1
Remote Supervisor Control C-1
codes 6-7
mounting C-1
wiring C-1
operation C-3
report
closed input circuits 6-12
status only 3-3
reset
alarm time 5-4, 6-22
clear a program, 3-1, 6-27
Return To Normal (RTN) E-1
returning parts 9-4
ring answer delay 6-23
ring back K-3
rotary flow meters 6-12
Run Time Meter 3-3, 6-11, I-2
inputs I-4
S
SCADA E-2 thru E-4
scaling factors
programming B-3
Security Access Code 6-24
seizure, line H-8
Serial Port Parameters F-18
Serial Printer Interface D-1
set points, high/low analog B-8
setting
recording rate 4-3, 4-5
touch or tone dialing 3-2
settings
review 6-1
speaker
adjusting volume H-1
external connections H-2
operation 6-26
speakerphone I-5
Special Order Items I-7
speech messages
analog programming B-9
recording times H-5
Station ID 4-1
STATUS key 5-2
Status, network F-22