Raco Verbatim - Advanced Programming

Contents
ii Verbatim Owner's Manual
5.2 CHECK STATUS Inquiry at Panel ................................................ 5-1
5.3 Receiving Alarm Calls ................................................................... 5-2
5.4 Continued Dialing in the Absence of Acknowledgment ................ 5-3
5.5 Acknowledging the Alarm Call ...................................................... 5-4
5.6 Alarm Reset Timeout After Acknowledgment............................... 5-4
5.7 Programming by Phone .................................................................. 5-4
5.8 Dialing Out and Conversing Through the Verbatim Autodialer .... 5-6
6 Advanced Programming
6.1 Program Codes ............................................................................... 6-1
6.1.1 Notes for Programming Code Table: ............................................. 6-2
Programming Code Table .............................................................. 6-3
Programming Operations.............................................................. 6-10
6.2.1 Channel Status Reading ................................................................ 6-10
6.2.2 Message Recording and Reviewing ............................................. 6-10
6.2.3 Channel Programming (Configuring)........................................... 6-11
6.2.4 Run Time Meter Programming .................................................... 6-12
6.2.5 Pulse Totalizer Function Programming ........................................ 6-12
6.2.6 Alarm Trip Delays ........................................................................ 6-13
6.2.7 Phone Numbers and Pulse/Tone Dialing ...................................... 6-14
6.2.8 Enhanced Telephone Interface Features ....................................... 6-16
6.2.9 60 Digit Phone Numbers .............................................................. 6-17
6.2.10 Telephone Line Fault Detection (Phone Fault) ............................ 6-17
6.2.11 Automatic Tone/Pulse Selection .................................................. 6-18
6.2.12 Call Progress Monitoring (CPM) ................................................. 6-19
6.2.13 Alarm Call Grouping .................................................................... 6-21
6.2.14 Alarm Ready Scheduling .............................................................. 6-22
6.2.15 Local Data Logging Programming Codes .................................... 6-22
6.2.16 Analog Input Programming .......................................................... 6-22
6.2.17 Remote Supervisory Control ........................................................ 6-22
6.2.18 Data Acquisition/Central Data Logging ....................................... 6-22
6.2.19 Miscellaneous Programming Tips ................................................ 6-22
6.2.20 Program Clear Out Operations ..................................................... 6-27
6.2.21 (940) Diagnostic Readouts ........................................................... 6-28
7 Using the Alarm Ready Schedule Feature
7.1 Definition ........................................................................................ 7-1
7.2 General Descriptions ...................................................................... 7-1
7.3 Alarm Ready Schedule Modes ....................................................... 7-3
7.4 Weekday Schedule Mode 1 ............................................................ 7-4