Using Your Verbatim autodialer
5-6 Verbatim Owner's Manual
u If you initially enter a Command Tone "8" in place of the "1", the unit
will not be acknowledged and will immediately say "goodbye" and end
the phone call.
u If you initially enter a Command Tone of "0, 5, 6, 7, or 9," in place of the
"1", the alarms will acknowledge an alarm and the unit will immediately
say "goodbye" and end the phone call.
! Note:
Command tones "1, 2, 3, and 4" will acknowledge all alarms, even those not
in their Alarm Call Group (ACG). See Section 6.2.13. Command tones "0, 5,
6, 7, and 9" will acknowledge only alarms in their ACG. Command tone "8"
will not acknowledge any alarms, but will give the status of all alarms.
5.8 Dialing Out and Conversing Through the
Verbatim Autodialer
At the panel, starting in the Normal Mode, press the DIALOUT/PRESS TO
TALK key. Next press the digits of the phone number you want to dial. Each
digit you press will be dialed as you press it. You will then hear the sound of the
ringing.
When you hear the phone answered, press and hold the same DIALOUT/
PRESS TO TALK key as you speak to the person on the line, and release the
key to listen. Continue the conversation in this manner.
u To end the call press NORMAL. If the DIALOUT/PRESS TO TALK key
is not pressed for more than 2 minutes (or as previously set), the Verbatim
autodialer will automatically end the call.
u To automatically re-dial a number that was previously manually entered
by this method, press DIALOUT/ PRESS TO TALK as before, then press
ENTER rather than entering digits manually.
If you are at the panel when a phone call is in progress, you may suspend the
message report and converse with the person on the other end by pressing the
DIALOUT/PRESS TO TALK key as described above. There will be no addi-
tional dialing, since connection has already been established. To end the call,
press NORMAL.
DIAL OUT
PRESS
TO TALK
NORMAL
CHECK
STATUS
To Next Page
Loading...
