Advanced Programming
6-22
Verbatim Owner's Manual
u To “un-link” channel ZZ so that it again calls all phone numbers,
press:
5 ZZ 9 POINT ENTER
u To undo all existing linkage on all channels, press:
9 35 2 ENTER
6.2.14 Alarm Ready Scheduling
Refer to Section 7, "Using the Alarm Ready Schedule Feature," for use and
application information. See also Appendix E , "Data Acquisition/Central Data
Logging."
6.2.15 Local Data Logging Programming Codes
Refer to Chapter 2, "Installation," for use and application information.
6.2.16 Analog Input Programming
Refer to Appendices B, C and D, "Analog Signal Input," "Remote Supervisory
Control Output," and "Printer Options," for use and application information.
6.2.17 Remote Supervisory Control
Refer to Appendices B, C and D, "Analog Signal Input," "Remote Supervisory
Control Output," and "Printer Options," for use and application information.
See also Appendix E, "Data Acquisition/Central Data Logging."
6.2.18 Data Acquisition/Central Data Logging
Refer to Appendix E, "Data Acquisition/Central Data Logging."
6.2.19 Miscellaneous Programming Tips
(903) Time Between Alarm Call Outs
This is the length of time after ending one alarm call-out and before beginning
the next call-out. Default value is 2 minutes; range is 0.1 to 99.9 minutes.
u To program a different number of minutes V, press:
9 03 V ENTER
To Next Page
Loading...
