Verbatim Series SFP Autodialer
A-6 Verbatim Owner's Manual
A.4 Using Your Programmed
Verbatim Autodialer
Section 5.7 is largely replaced by the discussion in Section 4 regarding over-
the-phone programming, except for discussion of the alternative command
codes “2,” “3,” “4,” and “0.”
Disregard Section 5.8.
A.5 Remainder of the Manual
All other descriptions in this manual may be followed and applied to the SFP
with no practical limitiations.
Note:
The lack of front panel programming has specific impact on some minor
aspects of specific programming items, as follows:
K CODE 910:
SECURITY ACCESS CODE No Security Access Code may be
programmed since this could only be programmed from the front
panel keyboard.
K When a delay between dialing digits is needed (as for pager
applications), it will only be possible to insert one delay period,
since this is done over the phone by pressing the # key, and if this
were pressed more than once in succession it would be interpreted
as a Cancel Entry command. Therefore to get the length of delay
desired, use 928 to extend the duration of the single delay from
its default value of one second, to whatever value is needed.
K CODE 926:
EXIT DELAY FUNCTION The Exit Delay function is not
applicable in the absence of the front panel keyboard.
K The Speakerphone/Dialout function is not applicable in the
absence of the front panel keyboard.
K There is no Parallel Printer Output.
To Next Page
Loading...
