RACOR PSM-1R User Manual (English)

To Next Page

H O M E S T O R A G E P R O D U C T S

WWW.RACORSTORAGESOLUTIONS.COM

WARNING

Please read installation instructions carefully prior to installing. Before using the product thoroughly test the fully-weighted

product (with equipment in place) to ensure the product has been installed properly. Do not allow children to play on

product. ITW Brands is not responsible for any damage resulting from improper installation, overloading or product failure.

WHEELBARROW AND

LADDER HANGER | PSM-1R

INSTRUCTIONS

Verify the height of the hook is at a

convenient location and that the

wheelbarrow or ladder has adequate

clearance once hanging.

Position the bracket on the wall with enough

ceiling and ﬂoor clearance for the wheelbarrow

or ladder. Make sure the rack is level.

Mark holes through rack mounting plate, drill

1/8” pilot holes and install screws into stud.

Tighten screws ﬁrmly.

Phillips driver

1/8” Drill bit

Drill

TOOLS REQUIRED

x2 2’’ (5 cm) wood screws

PARTS LIST

x1 Bracket

Clearance

MARK

Need help?

Do you have a question about the RACOR PSM-1R and is the answer not in the manual?

RACOR PSM-1R Specifications

General

Read instructions carefully before installing. Test thoroughly after installation. Do not allow children to play on product.

Verify hook height and clearance. Position bracket level, mark holes, drill pilot holes, and install screws into stud.

Place the back of the wheelbarrow or the rung of the ladder into the bracket recess for secure holding.

Wheelbarrow is held by bracket lip and arms against wall; ladder is held by its rung.