8
4: Netzschalter:
Toggle Switch:
Stecken Sie das Netzkabel in den Netzanschluss [AC-IN] (auf der linken Seite des
Geräts) oder legen Sie vier AA-Trockenbatterien [1,5 V × 4 AA] ein. Das LCD
zeigt die Uhrzeit an.
Bewegen Sie den Schalter in die Position [ON], um das Radio einzuschalten.
Bewegen Sie den Schalter in die Position [OFF], um das Radio auszuschalten.
5: Lautstärkeeinstellung:
In operating mode, you can adjust the volume as needed by rotating the volume
knob. Tur
ning the volume knob in the 'MIN' direction decrease the volu
me,
while turning it in the 'MAX' direction increase the volume."
6: Hören von Radi osendungen:
6.1: Drücken Sie im eingeschalteten Zustand des Radios den
Vier-Positions-Schalter, um die Modustaste auszuwählen.
Dieses Produkt kann FM, Mittelwelle und Kurzwelle empfangen. Die
Empfangsbereiche und Schrittwerte für jedes Band sind wie folgt:
6.2: Methode zum Anpassen des Mittelwellen-Schrittwerts:
For me
dium wave reception, different countries have different requirements, and you
can adjust it according to your needs.
Clock Display Mode: Long press the [ ] button for approximately 3 seconds, and
the LCD screen will display the "10KHZ" character.
Press the [ ] button again, and it will toggle between the step values "9KHZ /
10KHZ." After about 1.5 se conds, the number disappears, and the last selected step
value becomes the default.
Note: In the United States, Canada, Mexico
, and other North and South American
countries, the medium wave step value must be set to 10KHZ, w hile in other
countries, the step value is 9KHZ.
6.3: Dieses Produkt unterstü tzt mehrere Abstimmungsmethoden: manuelle
Abstimmung, automatische Suche nach Radiosendern und voll automatische
Speicherung von Radiosendern.
6.3.1: Manual Tuning: Rotate the [ ] knob to increase or decrease the
frequency in each band by the minimum step value.
6.3.2: Automatic Radio Station Se
arch: P ress and hold [▲or▼] for 2 seconds to
quickly search for radio stations in an upward or downw ard direction using the
minimum step value. When a station with a signal is found, the search stops, and the
station starts playing.
6.3.3: Full Automatic Radio Station Storage: In the radio broadcast mode, press and
hold [ ] for 2 seconds to initiate a full automatic scan for radio stations. The
device will automatically store sta tions from the lowest to the highest frequency
po
int. During the full automatic scanning process, the LCD will display "SCAN" in
the upper left corner and the station's address number in the upper right corner as
"M**" (the number represents the station's address number). After completi ng one
Frequency Band Reception Range Step Value
AM 1: 522-1710KHZ
9KHz (Factory default is a 9KHz step value for
AM)
AM 2: 520-1710KHZ 10KHZ
FM FM: 64.00-108.00MHZ 0.1MHZ
SW short wave: 2.300-23.000MHZ 0.005HZ
To Next Page
Loading...
