Need help?Do you have a question about the Radiant Communications VL4510C and is the answer not in the manual?
General| Brand | Radiant Communications |
|---|---|
| Model | VL4510C |
| Category | Media Converter |
| Language | English |
Describes the VL4500 Series encoders' capability to deliver HD and SD content for live streaming and various business models.
Details SDI, ASI, Serial, TS, MGMT, QAM, and power ports across different models.
Illustrates rear panel ports for VL4528, VL4521, and VL4522 models.
Covers various SDI, Fiber SDI, CVBS, and Analog Audio input types and selection.
Explains the use of the Ethernet Management Port for monitoring and upgrades.
Details the 12V DC power input requirements and chassis ground connection.
Compares MPEG2 and H.264 encoding parameters like Chroma, Resolution, Frame Rate, Aspect Ratio.
Provides instructions for rack mounting, screw usage, and recommended spacing for airflow.
Explains connecting the power supply, LED behavior, and the standard boot-up time.
Explains control via front panel, RS232, or TS port for management.
Guides setting up a networked PC by matching the subnet to the VL4500's default IP address.
Instructs to open a web browser and enter the VL4500's IP address to access the management interface.
Explains accessing the VL4500 via Ethernet interfaces and lists configuration tabs.
Lists supported video input formats: 1080p, 1080i, 720p, and 480i with their respective frame rates.
Details settings for Video Input (Source, Rate, Resolution) and Output (Codec, Bit Rate, Aspect Ratio).
Details bitrate ranges and provides recommended settings in a table format.
Recommends GOP size for motion and explains dual stream (HD+SD) output functionality.
Covers selection of aspect ratio, scaling modes, and rate control (CBR vs VBR).
Details h.264 AVC codec modes: MBAFF, ARF, and SPF, with their characteristics.
Provides recommended I-Frame intervals based on frame rate and explains B-frame impact on latency.
Covers TS and Management Ethernet port settings: MAC, VLAN ID, IP Address, Netmask, Gateway.
Advises enabling QBA for SD output and explains local/centralized security options.
Provides steps to obtain the latest FW release and upload it using the software updater.
Details the process of browsing for the update.img file and clicking 'Upload and Update'.
To Next Page
