Radiant SFK 55

To Next Page

To Previous Page

SFK 55 - RAD - ING - Manual - 1512.2_CSA_TTS

SUMMARY

INTRODUCTION 4

1. INSTALLER SECTION 7

1.1. INSTALLATION 8

1.1.1. GENERAL INSTALL ATION WARNINGS 8

1.1.2. WATER HEATER LOCATION ENVIRONMENTAL REQUIREMENTS 8

1.1.3. REFERENCE LEGISLATION 9

1.1.4. UNPACKING 10

1.1.5. OVERALL DIMENSIONS (inch) 11

1.1.6. POSITIONING AND CLEARANCES TO COMBUSTIBLE MATERIAL AND SERVICE CLEARANCES 12

1.1.8. CIRCULATOR PERFORMANCE CURVE 14

1.1.9. WATER CONNECTION 15

1.1.10. RECIRCULATION MODE 16

1.1.11. PIPING DIAGRAM FOR BASIC INSTALLATION 17

1.1.12. CONDENSATE DRAIN 18

1.1.13. ANTI-FREEZE PROTECTION 20

1.1.14. PRESSURE RELIEF VALVE KIT 21

1.1.15. GAS CONNECTION 22

1.1.16. ELECTRICAL CONNECTION 22

1.1.17. POWER SUPPLY 23

1.1.18. OPTIONAL ELECTRICAL CONNECTIONS 24

1.1.19. VENTING 25

1.1.20. TYPES OF EXHAUST SYSTEMS 27

1.1.21. TABLE 1: ALLOWABLE VENT LENGTHS 31

2. SUPPORT CENTER SECTION 33

2.1. FIRST START-UP 34

2.1.1. PRELIMINARY OPERATIONS FOR FIRST START-UP 34

2.1.2. WATER HEATERS COMMISSIONING 35

2.1.3. CO2 VALUE CHECK AND CALIBRATION 36

2.1.4. ACCESSING AND PROGRAMMING THE PARAMETERS 37

2.1.5. PARAMETERS TABLE 39

2.2. MAINTENANCE 43

2.2.6. GENERAL MAINTENANCE WARNINGS 43

2.2.7. TECHNICAL DATA 44

2.2.8. TECHNICAL ASSEMBLY 46

2.2.9. INTERNAL PIPING SCHEMATIC 47

2.2.10. OPERATIONAL SCHEMES 48

2.2.11. WIRING DIAGRAM 49

Radiant SFK 55 - Page 2