Radiant SFK 56 User Manual

SFK 56 - RAD - ING - Inst.Manual - 2007.1_CSA
Installation and
Maintenance Manual for
model
WARNING
If the information in these instructions is not followed exactly, a fire or explosion may result causing property
damage, personal injury or death.
FOR YOUR SAFETY
— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
— Installation on and service must be performed by a qualified installer, service agency or the gas supplier.
SFK 56

Radiant SFK 56 Specifications

General

Brand	Radiant
Model	SFK 56
Category	Water Heater
Language	English

Summary

Introduction to the Radiant SFK 56 Manual

Manual Structure and Symbols Guide

Explains manual structure, symbols, and user indicators for easier understanding.

Manufacturer Warranty and Product Compliance

Details warranty terms, service requirements, and product conformity declarations.

1. Installer Section: Installation Procedures

1.1. INSTALLATION OVERVIEW

General installation overview, responsibilities, and compliance requirements.

1.1.1. GENERAL INSTALLATION WARNINGS

Critical safety warnings, code compliance, and unit purpose for installation.

1.1.2. WATER HEATER LOCATION REQUIREMENTS

Specifies environmental needs and air supply for safe water heater placement.

1.1.4. UNPACKING AND DIMENSIONS

Procedures for safe unit unpacking and key physical dimensions.

1.1.6. POSITIONING AND CLEARANCES

Details clearances to combustible materials and required service access space.

1.1.9. WATER CONNECTION

Guides for connecting domestic and heating water circuits, including safety.

1.1.16. GAS CONNECTION

Guidelines for safe and compliant gas piping installation and leak checks.

1.1.17. ELECTRICAL CONNECTION

Procedures for safe electrical grounding and power supply connection.

1.1.20. VENTING

Requirements for proper exhaust and air intake venting systems for safe operation.

1.1.22. ALLOWABLE VENT LENGTHS

Table specifying maximum allowable vent lengths and elbow equivalencies.

2. Support Centre Section: Operation and Maintenance

2.1. FIRST START-UP PROCEDURE

Steps for initial unit setup, adjustment, and operation checks post-installation.

2.1.3. CO2 VALUE CHECK AND CALIBRATION

Procedure for measuring and adjusting CO2 levels for optimal combustion efficiency.

2.1.4. ACCESSING AND PROGRAMMING PARAMETERS

Guide to navigate and modify unit settings via the control panel.

2.1.5. PARAMETERS TABLE

Reference table detailing available parameters, their ranges, and functions.

2.2. MAINTENANCE GUIDELINES

General safety warnings and annual maintenance procedures for unit longevity.

2.2.8. TECHNICAL DATA

Comprehensive technical specifications, performance data, and unit dimensions.

2.2.16. FAULT SIGNALLING CODES

List of error codes, causes, solutions, and reset procedures for troubleshooting.

2.2.19. CONVERSION TO DIFFERENT GAS TYPE

Step-by-step instructions for converting the unit to operate with a different fuel type.