2
SFK 56 - RAD - ING - Inst.Manual - 2007.1_CSA
SUMMARY
SUMMARY
INTRODUCTION 4
1. INSTALLER SECTION 7
1.1. INSTALLATION 8
1.1.1. GENERAL INSTALLATION WARNINGS 8
1.1.2. WATER HEATER LOCATION ENVIRONMENTAL REQUIREMENTS 8
1.1.3. REFERENCE LEGISLATION 9
1.1.4. UNPACKING 10
1.1.5. OVERALL DIMENSIONS (inch) 11
1.1.6. POSITIONING AND CLEARANCES TO COMBUSTIBLE MATERIAL AND SERVICE CLEARANCES 12
1.1.7. ATTACHING THE WATER HEATERS TO WALL 12
1.1.8. CIRCULATOR PERFORMANCE CURVE 14
1.1.9. WATER CONNECTION 15
1.1.10. RECIRCULATION MODE 16
1.1.11. EXTERNAL RECIRCULATION IN COMBINATION MODE 19
1.1.12. PIPING DIAGRAM FOR BASIC INSTALLATION 20
1.1.13. CONDENSATE DRAIN 21
1.1.14. ANTI-FREEZE PROTECTION 23
1.1.15. PRESSURE RELIEF VALVE KIT 24
1.1.16. GA S CONNECTION 25
1.1.17. ELECTRICAL CONNECTION 25
1.1.18. POWER SUPPLY 27
1.1.19. OPTIONAL ELECTRICAL CONNECTIONS 28
1.1.20. VENTING 30
1.1.21. TYPES OF EXHAUST SYSTEMS 33
1.1.22. TABLE 1: ALLOWABLE VENT LENGTHS 38
2. SUPPORT CENTRE SECTION 41
2.1. FIRST START-UP 42
2.1.1. PRELIMINARY OPERATIONS FOR FIRST START-UP 42
2.1.2. WATER HEATERS COMMISSIONING 43
2.1.3. CO2 VALUE CHECK AND CALIBRATION 44
2.1.4. ACCESSING AND PROGRAMMING THE PARAMETERS 45
2.1.5. PARAMETERS TABLE 47
2.1.6. COMBUSTION BLOWER FREQUENCY/HEAT CAPACITY DIAGRAM 54
2.2. MAINTENANCE 55
2.2.7. GENERAL MAINTENANCE WARNINGS 55
2.2.8. TECHNICAL DATA 57
2.2.9. TECHNICAL ASSEMBLY 59
To Next Page
Loading...
