To Next PageTo Next PageWhy does my Radient ORIGIN reset charge current to 0.5A automatically?
The Radient Battery Charger may reset the charge current to 0.5A automatically as a built-in safety feature. This function is activated after a battery is disconnected or an error is cleared.
Why is the status LED flashing red on my Radient Battery Charger?
If the status LED on your Radient Battery Charger is flashing red, it could be due to several reasons: * The battery voltage might be too low. * The battery voltage might be too high. * The input voltage is too low. * There could be reverse polarity.
How to fix a Radient Battery Charger that is unresponsive to starting?
If the Radient Battery Charger is unresponsive when starting, make sure you are pressing the button down for long enough.
Provides information on charging status, errors, and connection issues.
Controls charge current selection, cycle start/stop, and error clearing.
Connects the charger to the battery using the appropriate connector.
Covers ventilation, environment, power source, battery type, and handling.
Avoid flammables, damaged batteries, unattended charging, and moisture.
Crucial for correct charging: identify NiCd/NiMH vs. LiPo packs.
Steps include plugging in, connecting battery, following instructions, and unplugging.
Ensure battery labels clearly state NiCd or NiMH, capacity, and voltage.
Supports NiXX with delta peak and 0.5-4A current for 1-8 cells.
Steps for connecting leads, selecting current, and starting charge.
General| Brand | Radient |
|---|---|
| Model | ORIGIN |
| Category | Battery Charger |
| Language | English |
