76
SPECTRALIS
3.5.2 Option 1: Adjusting preset value and entering steps
Push the [Function]-button in the sequence-edit section and select page 1/7 of the
sequence edit menu by hitting the [page-down]-button if not already selected.
1/7:Fnc TrigMod->TGrp1 Stp:01-16
Seq:L11 ^Pitch:A3 ^Len:1 ^Vel:92
Next select a note-line (TGrp1) with the first encoder and set the values for pitch,
length and velocity in the display menu. By hitting numeric buttons 1-16, you can
copy the defined parameterset to the corresponding stepnumbers.
If you want to erase one of the steps, simply push the according numeric button
again.
If you want to change an existing step, adjust the values in the display and push the
desired numeric button again. The step won’t be erased but changed, if it's values
differ from the display parameterset.
In this mode you can additionally change the pitch of the steps with encoders 1-16
3.5.3 Option 2: Setting pitch, length, probability and dynamic value
separately
On menu-page 1/7 you may already have noticed a little arrow pointing upwards in
front of the entries “Pitch”, “Length” and “Velocity”. This arrow indicates, that there
is an additional menu page which you can access by pushing the according
encoderbutton.
Changing the pitch
Push the encoder button (Pitch). The following menu will open:
1/4: Pitch->TGrp1 Stp:01-16
Seq:L11 Pitch:A3 [SetAll]
In this menu you can determine the pitch, which you can apply to individual steps by
pushing the according numeric buttons 1-16 or use as a global overwrite for all steps
by using control button [SetAll]. In the menu all numeric buttons with a parameter
value different from the displayed value will blink. Buttons with conforming value will
be lit.
You will find this blink/lit display in all of the following menus.
Changing the trigger-probability
Using the [Page-Up]-button will get you to the next menu-page:
2/4:Probability->TGrp1 Stp:01-16
Seq:L11 Prob:100% [SET All]
In this menu page you can adjust the probability for the triggering of a note separately
for each step. At 100% the note will be triggered during each pass. The lower the set
value the less the probability that the note will actually be triggered. Use the numeric
buttons to copy the value displayed to additional steps. You will also be able to see
Step-sequencer advanced - Tonal sequences
To Next Page
