EasyManua.ls Logo

Radinn Freeride - Page 24

Default Icon
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
General Safety Information
Concerning the Radinn jetboard
Always make sure to prepare the jetboard out-
side of the water. It is important that the Radinn
Power Pack is ONLY connected in a dry area.
If connected in or near water there is always an
inherent risk of short circuits which can result in
severe damage, injury or death.
After riding, always tilt the jetboard to allow for
water to drain properly. Make sure no water en-
ters the board’s connector while draining.
Make sure not to reach into the jet and remove
sea grass or similar in the jet with your hands.
There is a high-speed rotating impeller inside
the jet that can cause severe injury. Make sure
that there are no other people, such as kids,
nearby that can reach into the jet.
Be careful to ride where there is no or little
chance of sea grass or similar debris to get into
the system. If this would occur, NEVER try to
remove this while the jetboard is still in water
and the magnetic safety leash is attached to the
board.
If there is any dirt, sand, rope, stone, sea grass
or foreign objects in the jet channel or the jet,
do NOT ride the jetboard. If the procedure of
removing the debris is simple, make sure that
the magnetic safety leash is removed and NEV-
ER use your hands or body parts to remove it. If
it is a complex procedure, contact your closest
authorized Radinn representative or retailer for
servicing.
Never leave the jetboard unattended so that
kids or other inexperienced people can’t un-
intentionally or intentionally start it, use it and
risk injury of themselves or others. Always bring
your magnetic safety leash with you to prevent
accidents.
SAFETY INFORMATION

Related product manuals